Rising water

Raise the sea around a hill one contour interval at a time, and see that each contour line is the edge of the water at one elevation.

Unit 4: Elevation, contours and slope

How to use it

Drag the slider, or press an arrow key, to raise or lower the water by one contour interval. Page Up and Page Down move five intervals, from one index contour to the next, and Home and End go to the lowest line and to the highest line. The map draws a brown line at each elevation that the water reached, and the side view shows the water along a line from west to east over the top.

The map of Mile's End. The place is made up.Pixel Peak is a made-up hill. Contour lines from 1,100 to 1,200 feet, every 20 feet. The labeled lines are every 100 feet. The highlighted line is at 1,200 feet. The water covers the land below 1,200 feet. The blue line is a stream. The closed line with short ticks is a depression. The spot elevation on the top is 1,392 feet. The benchmark, BM, is at 1,091 feet.1,1001,2001,392BM 1,091AB

A contour line is the edge of the water if the sea rose to that elevation.

The side view shows the land along the line from A to B, over the top of the hill, drawn 2.5 times taller than true scale. The water fills the low ground up to 1,200 feet.AB

Press an arrow key to move the water one contour interval, or Page Up or Page Down to move five intervals, from one index contour to the next. Home and End go to the lowest line and to the highest line.

Water at 1,200 feet. Lines at 6 elevations. Contour interval: 20 feet. Every fifth line is an index contour.

In the decks

All tools

main fb25b7f