Remote Sensing B, unit 4 homework: Elevation, contours and slope
Read this deck before the session of unit 4. It takes about 15 minutes.
Goal: Find the elevation of a point from the contour lines, and calculate the slope between two points.
At the end, three questions check what you learned. Answer each one before you go to the next slide.
Elevation and altitude
- The elevation of a point is the height of the ground there above mean sea level.
- Altitude is the height of a thing above sea level when it is not on the ground, for example an airplane.
- A topographic map gives elevations in feet or in meters. Read the margin to find which.
Heights and distances have the same scale.
Altitude of the airplane 3,000 feet
Elevation of the ground below it about 1,390 feet
Height above the ground about 1,610 feet
Elevation of the hiker about 1,390 feet
A side view of the hill Pixel Peak along a line from west to east. Sea level is at the bottom, and a guide line marks each 1,000 feet. An airplane flies above the hill, and a dashed line drops from it to the ground. A hiker stands on the ground. Heights and distances have the same scale. Drag the airplane to fly it, and drag the hiker to walk. With a keyboard, press Tab to move from the airplane to the hiker, the Left and Right arrow keys to move 100 m, and the Up and Down arrow keys to change the altitude by 100 feet.
Contour lines
- A contour line joins points of the same elevation. On a USGS map, contour lines are brown.
- A hill is a set of closed lines, one inside the other. The smallest closed line is near the top.
- Two contour lines never cross.
From the map to the side
- This model of Pixel Peak has one layer for each contour line. Each layer is the land at or above the elevation of its line.
- Start at the map, and tilt the model from the top to the side. From above, the edge of each layer is a contour line, and the map becomes the model.
The contour map. Each line is the edge of one layer.
The contour interval
- The contour interval is the difference in elevation between two contour lines next to each other. The margin gives it, for example "Contour interval 20 feet".
- Every fifth line is an index contour. It is thicker, and its elevation is printed on it.
- A point between the 1,340 foot line and the 1,360 foot line is higher than 1,340 feet and lower than 1,360 feet. Halfway between the lines, estimate 1,350 feet.
- The top of a hill is higher than its highest closed line, and lower than that line plus one interval.
The edge of the water
- Move the slider to raise the water around Pixel Peak, one contour interval at a time.
- At each step, the edge of the water is one more contour line. Every point on that edge has the same elevation.
A contour line is the edge of the water if the sea rose to that elevation.
Press an arrow key to move the water one contour interval, or Page Up or Page Down to move five intervals, from one index contour to the next. Home and End go to the lowest line and to the highest line.
Water at 1,200 feet. Lines at 6 elevations. Contour interval: 20 feet. Every fifth line is an index contour.
Steep and gentle
- Lines close together show steep land. Lines far apart show gentle land.
- A profile is the side view of the land along a line on the map.
Step 3 of 3: a smooth line through the points.
Step 1 of 3: a mark on the strip at each contour line.
Steepest: between the 1,220 foot line and the 1,320 foot line.
Steepest: between the 1,380 foot line and the 1,380 foot line.
Gentlest: between the 1,120 foot line and the 1,100 foot line.
Gentlest: between the 1,380 foot line and the 1,380 foot line.
A line runs across Pixel Peak from end A to end B, 1,160 m long. It crosses 30 contour lines, thus the strip has 30 marks. Along the line, the land is highest at about 1,390 feet and lowest at about 1,090 feet. The strip shows the marks, and the graph shows a point for each mark and a smooth line through the points. The steepest stretch is between the 1,220 foot line and the 1,320 foot line. The gentlest stretch is between the 1,120 foot line and the 1,100 foot line. The height is stretched 5 times.
Streams and depressions
- Where a contour line crosses a stream, it bends into a V, or into a U in a wide valley. The bend points uphill, and along a stream, uphill is upstream.
- A V that points downhill shows a ridge: a long, narrow strip of high land.
- A closed line with short ticks on its inside edge shows a depression: a low area with no outlet.
- A spot elevation is a point with its elevation printed beside it. A benchmark (BM) is a point that surveyors measured with care.
Lower than 1,140 feet and higher than 1,120 feet, inside a depression.
Higher than 1,380 feet and lower than 1,400 feet, inside the highest closed line.
The ground at the pin: 1,392.11 feet.
A map of Pixel Peak from above, with a contour line every 20 feet. Drag the pin, or tap the map, to move it. The pin snaps to the spot elevation on the top and to the benchmark, BM, when it is close. Press an arrow key to move the pin 10 m, or 100 m with Shift.
Slope
- The slope between two points is the rise (the change in elevation) divided by the run (the distance on the ground between them).
- Use the same unit for the rise and the run.
- Example: a rise of 100 m over a run of 1,000 m is a slope of 0.1, or 1 in 10.
- For a stream, the gradient is often given in feet per mile.
Run: 1,000 m
Rise: 100 m
Slope: 100 ÷ 1,000 = 0.1, or 1 in 10
Gradient: 528 feet per mile
Run: 2.75 inches is 5,500 feet on the ground
Rise: 6,000 feet
Slope: 40 ÷ 5,500 = 0.00727, or about 1 in 138
Gradient: about 5,262 feet per mile
A side view of a straight path from point A, low, to point B, high. The run is along the bottom, the rise is up the side, and the path is the slanted side. The drawing has its true shape, with no stretch.
A circle for the slope
Cover the part that you want.
rise (change in elevation) = slope × run
slope (how steep it is) = rise ÷ run
run (distance on the ground) = rise ÷ slope
Which way does it flow?
- Each stream crosses contour lines. Find the V's. Then tap the end of the stream where the water goes, and check.
- If two lines have labels, the water flows from the higher line toward the lower line.
Tap the end of the stream where the water goes.
A stream runs between the top left and the bottom right of the map. It crosses 5 contour lines, and each line bends into a V that points toward the top left.
Question 1
Contour lines cross a stream, and each line makes a V. Which way does the V point?
- Choice 1: 1Downstream
- Choice 2: 2Toward the nearest road
- Choice 3: 3Toward north
- Choice 4: 4Upstream
Answer 1
Contour lines cross a stream, and each line makes a V. Which way does the V point?
- Choice 1: 1Downstream
- Choice 2: 2Toward the nearest road
- Choice 3: 3Toward north
- Choice 4: 4Upstream ✓ Correct answer
Why: Where a contour line crosses a stream, it bends up the valley, so the V points uphill. Along a stream, uphill is upstream. The stream flows the other way.
Question 2
A map has a contour interval of 10 m. An index contour is labeled 400. What is the elevation of the next index contour uphill?
- Choice 1: 1410 m
- Choice 2: 2450 m
- Choice 3: 3500 m
- Choice 4: 4440 m
Answer 2
A map has a contour interval of 10 m. An index contour is labeled 400. What is the elevation of the next index contour uphill?
- Choice 1: 1410 m
- Choice 2: 2450 m ✓ Correct answer
- Choice 3: 3500 m
- Choice 4: 4440 m
Why: An index contour is every fifth line, so two index contours are 5 × 10 m = 50 m apart: 400 m + 50 m = 450 m. 410 m is the next contour line, not the next index contour.
Question 3
On one side of a hill, the contour lines are close together. On the other side, they are far apart. Which is true?
- Choice 1: 1The side with the lines far apart is steeper.
- Choice 2: 2The two sides have the same slope.
- Choice 3: 3The side with the lines close together is steeper.
- Choice 4: 4The lines close together show a lake.
Answer 3
On one side of a hill, the contour lines are close together. On the other side, they are far apart. Which is true?
- Choice 1: 1The side with the lines far apart is steeper.
- Choice 2: 2The two sides have the same slope.
- Choice 3: 3The side with the lines close together is steeper. ✓ Correct answer
- Choice 4: 4The lines close together show a lake.
Why: Lines close together mean that the elevation changes much over a short distance, so the land is steep. Lines far apart mean gentle land.
Before the session
- Bring a metric ruler, a calculator and your binder.
- The new words of unit 4: elevation, altitude, contour line, contour interval, index contour, profile, ridge, depression, spot elevation, benchmark, slope, rise, run, gradient. The index of your binder gives the meaning of each one.
- To read more: Elevations and Contours and Topographic Map: Kellogg West, Idaho, 1996.
Flash cards: Practice unit 4