Unit 2 review: Map basics

Fill each blank in the session. At home, check each blank with the review handout of unit 2 at remotesensing.fyi, and correct it. Keep this page in your binder, behind the tab of unit 2.

What we learned

  1. The at the edges of a map gives its location, its , its scale, its orientation and what its symbols mean. Read this information before you read the map.
  2. At a scale of 1:24,000, 1 cm on the map is on the ground, and 1 inch is .
  3. A , such as 1:24,000, shows a small area with much detail. A , such as 1:1,000,000, shows a large area with less detail.
  4. A map gives its scale as a ratio, in words, or as a . The third form stays true when the map is printed larger or smaller, or shown on a screen, because it changes size with the map.
  5. (a star on a USGS map) points to the North Pole. A compass points to . The angle between them, the magnetic declination, changes with place and time.
  6. The gives the meaning of each symbol and color. On a USGS map: blue for water, green for woods, brown for contour lines, black for most roads and buildings, and red for main roads.
  7. An azimuth is one angle, measured from north: north is 0° and east is 90°.
  8. A bearing turns from toward East or West. A is 180° away.

Traps

  1. Count the zeros.

    Do not: write 150 m or 15 km for 3 cm at 1:50,000.

    Do: write each step. 3 cm × 50,000 = 150,000 cm, and 1 km is 100,000 cm, thus it is .

    Drill it: Map ruler

  2. A map at 1:1,000,000.

    Do not: call 1:1,000,000 the larger scale because 1,000,000 is the larger number.

    Do: read the number after "1:". The larger the number, .

  3. A ratio is not true on a screen.

    Do not: measure a map on a screen with a ruler, and then use the ratio of the map.

    Do: mark the two points on a strip of paper, and read the distance on the .

  4. A quarter turn from north.

    Do not: call west 90° because west is a quarter turn from north.

    Do: start at north, 0°, and turn . East is 90°, south is 180°, and west is 270°.

    Drill it: Azimuth dial

  5. A bearing never has more than 90°.

    Do not: write 230° as "West 40° South" or as "South 230° West".

    Do: count from south (180°) toward west: South (230° − 180°) West = .

    Drill it: Bearing builder

  6. The opposite direction.

    Do not: subtract the azimuth from 180°, as in 180° − 40° = 140°.

    Do: if it is under 180°, add 180°: 40° + 180° = . If not, subtract 180°: 330° − 180° = 150°.

    Drill it: There and back

  7. Hold the protractor on north.

    Do not: read the protractor while it turns, or while its 0° does not point to north.

    Do: put the of the protractor on the start point, turn 0° to north along a grid line or the edge of the map, and hold it still. Then read the degrees where the line to the target crosses the edge.

    Drill it: Place the protractor

  8. An old map.

    Do not: compare two maps, or use the declination of an old map, before you read the margin.

    Do: read the of each map first, because roads and the declination change with time.

    Drill it: Magnetic declination

Practice this unit with its flash cards: open remotesensing.fyi, and find unit 2.

main fb25b7f